Unfolding the PedalPC
With the machine sitting on the ground, lift the machine by the backrest until the front leg contacts the ground.

front leg not contacting floor

front leg contacting floor
Swing the rear leg backward by pushing it with your foot until the rear leg is fully extended.

moving rear leg backward with foot–
starting position

moving rear leg backward with foot–
middle position

rear leg extended fully backward
Seat Adjustment
Push the desk forward as far as it will go.

desk pushed forward
Loosen the seat clamp knob, pull the seat out slightly, and retighten the clamp knob.

loosening the seat clamp knob

pulling seat from clamp
Sit on the seat and put your feet on the pedals to check the seat position.

Sit on seat to check seat adjustment
If the seat is too close or too far from the cranks, loosen the seat clamp knob and adjust the seat position. Retighten the clamp.
Desk Adjustment
While sitting on the seat, loosen the desk clamp knob, and pull the desk partly out of the clamp until it is in a comfortable position for you.

loosening desk clamp

pulling desk out of clamp
Put your feet on the pedals and rotate the cranks around until your right pedal is at the top of its stroke and the left pedal is at the bottom. Check your knee clearance. Once you are satisfied with it’s position, retighten the desk clamp knob.

checking knee clearance
Hold the desk in position with one hand and tighten the knob below it with the ohter to set the distance between the desk and your waist.

setting waist clearance